Parts List - Ferno 101-H User Manual

Model 101-H Operating Table
Parts Diagrams - continued
12
21
13

8.4 Parts list

No. Part Description
1 190-1270 Operator-end jack assy.
2 190-1271 Drain-end jack assy.
3 190-1272 Swivel caster w/lock (before 10C-051944)
190-2061 Swivel caster w/directional lock (for tables
serial number 10C-051944 and higher)
4 190-1273 Double-ended brake pedal
5 190-1274 Retention springs (set of 3)
6 190-1275 Bellows jack cover (each)
7 190-1276 (New) 101-H label sheet*
8 190-1277 (New) 101-H base cover (photo page 14)
9 190-1739 Left pedal weldment w/hardware (E)
10 190-1740 Center pedal weldment w/hardware (E)
11 190-1741 Right pedal weldment w/hardware (E)
12 190-1282 Rubber pedal pad (set of 3)
13 190-1742 Delrin spacer (set of 4) (E)
14 190-1743 Pedal bolt w/hardware (E)
© Ferno-Washington, Inc 234-1994-03 October 2010
1
9
10
11
4
14
Qty.
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
(Beneath 18,
not visible)
19
18
6
15
(Third spring
5
not visible)
No. Part Description
15 190-1285 Change-lever casting w/hardware
(1 each end, see photos pages 14, 15)
16 190-1286 Hex rod, long w/stops
17 190-1287 Hex rod, short w/stops (photo page 14)
18 190-1744 Release bar weldment, upper (E)
19 190-1745 Release bar weldment, lower (E)
20 190-1746 Release bar weldment, middle (E)
21 190-1747 Clevis pin set w/e-clip (E)
* Not Shown
(E) - For parts designated (E), tables before serial number
08C-010631 must be updated by EMSAR in the U.S.A. and
Canada (see Section 8.1, page 14). Outside the U.S.A. and
Canada, please contact your distributor for the update.
Once the update has been made, these and other parts can be
obtained and installed by the end user.
Parts and Service
2
20
3
16
Qty
1 only
1
1
1
1
1
1
15