Tilting The Table Top - Ferno 101-H User Manual

Using the Table

5.7 Tilting the Table Top

To tilt the table top:
1. Raise the table top to the desired height by pumping
the left foot pedal (Figure 12-A).
2. Lower the drain end of the table top by pushing the
right pedal down a short distance at a time until the
table top reaches the desired angle (Figure 12-B).
important
Tilt the table top only a few degrees at a time as
instructed above. Completely depressing the foot
pedal in a single motion will tilt the table top steeply,
which may cause the body to slide off.
3. When the procedure has been completed, push down
on the center pedal to lower the operator end of the
table top until it is level with the drain end (Figure
12-C).
4. To raise the table top again, pump the left foot pedal.
12
Model 101-H Operating Table
Figure 12-A - Raising the Table Top
To Working Height Before Tilting It
Figure 12-B - Tilting the Drain End of the Table Top
Figure 12-C - Returning the Table Top to the Level
© Ferno-Washington, Inc 234-1994-03 October 2010