Operation - ABB Robotics IRC5 Safety Manual

6 Operation

Lock and change of operating mode
To prevent hazard, it is the responsibility of the integrator to make sure that keys
used to lock or change the operating mode are handled only by authorized
personnel.
An IRC5 controller with a physical key for the mode selector, is designed so that
the key fits on all IRC5 controllers, unless unique keys are ordered.
Safety actuators not in use
Devices with safety actuators that are not connected to the robot or robot system
must be stored out of reach and sight so that they cannot be mistaken for being
connected.
Unexpected movement of robot arm
A robot may perform unexpected limited movement.
Safety manual for robot - Manipulator and IRC5 or OmniCore controller
3HAC031045-001 Revision: R
WARNING
Hazards due to the use of brake release devices and/or gravity beneath the
manipulator shall be considered.
WARNING
Manipulator movements can cause serious injuries on users and may damage
equipment.
© Copyright 2008-2021 ABB. All rights reserved.
6 Operation
23