DELTA LOGIC ACCON-NetLink-PRO User Manual page 15

Figure 7: Settings of the ACCON-NetLink-PRO compact
Static TCP/IP configuration
If the ACCON-NetLink-PRO compact is used in a network without a
DHCP server or if the ACCON-NetLink-PRO compact should always work
with the same IP address despite an existing DHCP server, you have to
enter the desired IP address into the input mask for »Static entries«. In
this case you must not set the function »Get IP address automatically
(DHCP)«.
The ACCON-NetLink-PRO compact's IP address must fit into your
network. For this the first three places of the IP address of the PC and
the ACCON-NetLink-PRO compact have to be equal, e. g. PC: IP address
192.168.4.10, ACCON-NetLink-PRO compact IP address 192.168.4.49
(only valid if subnet mask 255.255.255.0 is used).
Use of DHCP (Dynamic Host Configuration Protocol)
The problem with DHCP is, that after every switch-on the parametrized
ACCON-NetLink-PRO compact can get another IP address. The system
administrator responsible for the DHCP server can prevent it. The
ACCON-NetLink-PRO compact's MAC address must have a permanent IP
address at the DHCP server.
ACCON-NetLink-PRO compact 14