Table of Contents
Advertisement
2-3-7. WB-1002 Board
Preparation
1. Remove the top cabinet and the bottom cover. (Refer to "2-2. Top Cabinet, Bottom Cover".)
2. Remove the inside panel. (Refer to "2-3. Inside Panel".)
3. Remove the HP-1015 board. (Refer to "2-3-2. HP-1015 Board".)
4. Remove the FU-1001 board assembly. (Refer to "2-3-5. FU-1001 Board".)
5. Remove the TG-1005 board assembly and the SH-1030 board. (Refer to "2-3-6. TG-1005 Board,
SH-1030 Board".)
Procedure
1. Remove the WB-1002 board assembly.
WB-1002 board assembly
Hole
Boss
Note
•
When installing the WB-1002 board assembly, insert the two A portions into the two grooves, and
align the boss with the hole.
•
After installing the WB-1002 board assembly, check that the outer shape of the WB-1002 board
and the outer shape of the AF button rubber (88100) match.
A
Grooves
Confirmation at the time of installation
AF button rubber
(88100)
WB-1002 board
Tip
At the time of installation, pull the PUSH AUTO
button plate in the direction of the arrow to
attach it.
PUSH AUTO button plate
60
Advertisement
Table of Contents
