Dc-1023 Board - Sony ILME-FX6V Service Manual

2-15. DC-1023 Board

Preparation
1. Remove the top cabinet and the bottom cover. (Refer to "2-2. Top Cabinet, Bottom Cover".)
2. Remove the inside panel. (Refer to "2-3. Inside Panel".)
3. Remove the outside panel. (Refer to "2-4. Outside Panel".)
4. Remove the VC-1046 board. (Refer to "2-5. VC-1046 Board".)
5. Remove the CK-1027 board. (Refer to "2-8. CK-1027 Board".)
6. Remove the VF-1024 board. (Refer to "2-10. VF-1024 Board".)
7. Remove the JK-1029 board. (Refer to "2-11. JK-1029 Board".)
8. Remove the rear assembly. (Refer to "2-12. Rear Assembly".)
9. Remove the LC-1052 board. (Refer to "2-14. LC-1052 Board".)
Procedure
1. Disconnect the harness from the connector (CN101) on the DC-1023 board.
2. Remove the two screws, and then remove the DC-1023 board.
CN101
Boss
Hole
Harness
DC-1023 board
P1.7 x 3
107