Table of Contents
Advertisement
14. Disconnect the flexible flat cable from the connector (CN0100) on the SEL-1001 board.
15. Remove the PS-1004 board.
16. Disconnect the flexible flat cable from the connector (CN003) on the PS-1004 board.
Hole
Switch
Reinforcing plate side:
PS-1004 board
CN003
Flexible flat cable
Hole
Groove of the power switch
Bosses
SEL-1001 board
CN0100
Note
When installing the PS-1004 board, align the switch with the groove of the power switch.
17. Install the removed parts by reversing the steps of removal.
53
Advertisement
Table of Contents
