Table of Contents
Advertisement
2-12-2. SDI-1004 Board
Note
The following parts are not reusable. Prepare new parts in advance.
•
Tape AS: 1 pc
Preparation
1. Remove the top cabinet and the bottom cover. (Refer to "2-2. Top Cabinet, Bottom Cover".)
2. Remove the inside panel. (Refer to "2-3. Inside Panel".)
3. Remove the outside panel. (Refer to "2-4. Outside Panel".)
4. Remove the VC-1046 board. (Refer to "2-5. VC-1046 Board".)
5. Remove the CK-1027 board. (Refer to "2-8. CK-1027 Board".)
6. Remove the VF-1024 board. (Refer to "2-10. VF-1024 Board".)
Procedure
1. Disconnect the fine-wire coaxial cable from the connector (CN6001) on the SDI-1004 board.
2. Peel off the tape AS from the SDI shield case.
Note
The tape AS is not reusable.
Attaching position of the Tape AS and
arrangement of flexible flat cable
Shield case
Mountain fold
Note
•
Align the mountain fold portion of the flexible flat cable with the edge of the shield case.
•
Attach a new tape AS at the position as shown in the figure.
Tape AS
Tape AS
Fine-wire coaxial cable
CN6001
SDI-1004 board
SDI shield case
100
Advertisement
Table of Contents
