Table of Contents
Advertisement
FT-2001 board
The FT-2001 board contains an LED for FRONT TALLY.
IF-1014 board
The IF-1014 board is a unit-side connector board for relay between the unit and the handle.
This board relays the switch signals of the handle and power and communication lines of the internal
microphone in the handle, audio input connectors (INPUT1 and INPUT2), and MI SHOE.
VC-1046 board
The VC-1046 board contains video/audio signal processing devices, source oscillation devices, and power
devices to supply power to each IC.
Signal processing block
IC1000, IC2000, IC8000, IC9100 perform main video/audio signal processing.
IC1000 receives signals from the IS-1043 board through the connector (CN0602), processes them, and
then distributes them to each IC.
•
Video signals for the panel are sent through IC7500 to the panel connected to the PD-1066 board.
•
Signals for HDMI and control signals are sent to the driver on the HD-1006 board, and are then
output from the connector.
•
Signals for SDI output are output to IC8000, processed, and then output from the connector.
•
Video signals for recording in media are output to IC2000.
Furthermore, IC1000 controls imaging device, panel, lens, radiation fan, and devices (including RTC), as
well as handles key operation input signals.
IC1900 as a nonvolatile device of IC1000 is connected.
IC2000 receives signals from IC1000, processes them, and then outputs them to the SD card interface IC,
CFE card slot, and Wi-Fi processor IC. IC2000 also processes the input signals from these devices and
inputs/outputs the USB signals.
•
Signals for SD card are output through IC4700 to the SD card connectors (CN4200, CN4201).
The signals read from the SD card are processed through IC4700. The processed signals are also sent
to IC1000.
•
Signals for CFE card are output to the CFE card connectors (CN4200, CN4201).
The signals read from the CFE card are processed in IC2000. The processed signals are also sent to
IC1000.
•
Wi-Fi signals are output to the Wi-Fi processor IC on the CK-1027 board. At the same time, the input
signals from the Wi-Fi processor IC are processed in IC2000.
•
USB signals are input from and output to external devices through the Type-C connector (CN4100)
and the USB connector on the LC-1052 board.
Furthermore, IC2000 controls devices (such as NFC device and Wi-Fi processor IC) and inputs key
operation signals, and also modifies the device programs.
IC6280 as a nonvolatile device of IC2000 is connected.
IC8000 receives video signals, audio signals, control signals, and sync signals from IC1000. These
signals are sent to the SDI/TC driver, and are then output from the connectors.
9
Advertisement
Table of Contents
