Tg-1005 Board, Sh-1030 Board - Sony ILME-FX6V Service Manual

2-3-6. TG-1005 Board, SH-1030 Board

Preparation
1. Remove the top cabinet and the bottom cover. (Refer to "2-2. Top Cabinet, Bottom Cover".)
2. Remove the inside panel. (Refer to "2-3. Inside Panel".)
3. Remove the HP-1015 board. (Refer to "2-3-2. HP-1015 Board".)
Procedure
1. Disconnect the flexible flat cable from the connector (CN0002) on the SH-1030 board.
2. Remove the seven screws, and then remove the TG-1005 board assembly.
Holes
TG-1005 board
assembly
Flexible flat cable
Bosses
Note
When installing the TG-1005 board assembly, tighten screws (a) to (g) sequentially in alphabetical
order.
Screw tightening sequence
TP2 x 5
Hole
CN0002
SH-1030 board
Boss
(c)
(a)
(e)
(b)
(g) (f)
(d)
57