Handle; Hc-1002 Board - Sony ILME-FX6V Service Manual

2-16. Handle

2-16-1. HC-1002 Board

Procedure
1. Remove the five screws.
2. Lift the handle bottom cabinet about 1 cm.
Note
Be careful not to damage the flexible board by lifting the handle bottom cabinet too much.
3. Remove the HC-1002 board from the hole, and then disconnect the flexible board from the connector
(CN2402) on the HC-1002 board.
4. Remove the two handle connector cushions.
Handle bottom cabinet
P2 x 4
(c)
Note
At the time of installation, push the handle bottom cabinet in the direction of the arrow as shown in
the figure, and then tighten the screws in the following sequence: (a), (b), (c).
5. Install the removed parts by reversing the steps of removal.
P2 x 4
(a)
P2 x 4
(b)
Flexible board
Hole
HC-1002 board
CN2402
Flexible board
Pushing directions
(c)
HC-1002 board
Handle connector cushions
(a)
(b)
(b)
(b)
109