Notes For Replacing The Ck-1027 Board - Sony ILME-FX6V Service Manual

Work:
1. Execute [Read and Save] of "RESTORE DATA" in the DATA tab.
2. After replacement with the repair VC-1046 board, execute [LOAD and WRITE] of "PRODUCT
ID & USB SERIAL No. INPUT" in the ADJUST tab of the Adjust Manual to write extracted data
to the unit.
• When ID is unreadable
When ID adjustment values cannot be read, perform the following work.
Work:
After replacement with the repair VC-1046 board, start the Adjust Manual from the Adjust Station
and execute "PRODUCT ID & USB SERIAL No. INPUT" to enter ID.
Update of MAC Address
When a board that contains Wi-Fi has been replaced or when replacing a board that contains the main IC
(CPU) has been replaced, the MAC address must be reloaded.
Procedure of the MAC address update:
Note
Perform the following operations after all work has been done.
1. Start the Adjust Manual in the Adjust Station and execute "Wireless LAN Setting (MAC Address)"
on the ADJUST tab.
2. Perform "Network Reset" on the Network menu of the unit.
Note
After the replacement and repair, as the board has a new MAC address, ask the customer to configure the
devices connected to the unit again.
Accordingly, download the Flyer of WLAN Reset (Flyer of WLAN Reset_9834752[][].pdf) and print out
it, and attach it to the unit when returning the unit to customer.
Firmware Update
After replacing the VC-1046 board, update the firmware.
Note
When updating the firmware, do not use the USB Hub.

1-7-3. Notes for Replacing the CK-1027 Board

When the CK-1027 board is replaced, the MAC address must be updated.
Update the MAC address according to "Update of MAC Address" in "1-7-2. Notes for Replacing the
VC-1046 Board".
26