Sony ILME-FX6V Service Manual page 121

3. Disconnect the flexible flat cable from the (CN0010) on the HK-1003 board.
4. Disconnect the flexible board from the connector (CN0011) on the HK-1003 board.
5. Remove the six screws, and then remove the CNT dial assembly and the HK-1003 board.
Reinforcing plate side:
(b)
CNT dial assembly
Hole
Bosses
Note
When installing the HK-1003 board, align the handle hold switch with the switch of the HK-1003
board.
6. Install the removed parts by reversing the steps of removal.
Flexible flat cable
P2 x 4
CN0010
Flexible board
(a)
Groove
Handle hold
switch
(e)
Switch
(f)
(c)
Holes
P2 x 4
(d)
CN0011
HK-1003 board
Bosses
118