Hn-1054 Board - Sony ILME-FX6V Service Manual

2-16-4. HN-1054 Board

Preparation
1. Remove the HC-1002 board. (Refer to "2-16-1. HC-1002 Board".)
2. Remove the handle top cover assembly. (Refer to "2-16-2. Handle Top Cover Assembly".)
Procedure
1. Disconnect the flexible board from the connector (CN0401) on the HN-1054 board.
2. Disconnect the flexible flat cable from the connector (CN0405) on the HN-1054 board.
3. Remove the four screws.
CN0401
HN-1054 board
Note
• At the time of installation, tighten the screws in the following sequence: (a), (b), (c), (d).
• At the time of installation, arrange the flexible flat cable as shown in the figure.
Flexible board
(d)
(c)
CN0405
Flexible flat cable
Arrangement of flexible flat cable
P2 x 4
(b)
(a)
114