Replacing The Board; Board - Sony BRC-Z700 Service Manual

15. Remove the screw, then remove the ferrite fixing plate.
16. Remove the hook while pushing the clamp in the
inserting direction, then remove the clamp.
17. Pull out the LVDS harness assembly through the hole
of the tilt chassis.
18. Remove the clamp filter from the LVDS harness
assembly.
Clamp filter
PSW2.6 x 6
Ferrite fixing plate
LVDS harness
assembly
Tilt chassis assembly
19. Remove the LVDS harness assembly from the connec-
tor (CN2401) on the AD-181 board.
20. Remove the tape (L40), then remove the ferrite core.
21. Remove the hook while pushing the clamp in the
inserting direction, then remove the clamp.
22. Remove the ferrite core from the LVDS harness
assembly.
Tape (L40)
Hook
Clamp
LVDS harness
assembly
23. To install, reverse the removal procedure.
n
Replace the removed tape (L40) with the new tape (L40).
2-10
Clamp
Hook
Hole
Ferrite core
CN2401
AD-181 board

2-2. Replacing the Board

2-2-1. SY-354 Board
1. Remove the base plate assembly.
(Refer to Section 1-2-8.)
2. Remove the tape (A) and tape (L40).
3. Disconnect the eight flexible flat cables from the
connectors (CN002, CN003 and CN501 to CN506)
and disconnect the three harnesses from the connectors
(CN001, CN701 and CN702) on the SY-354 board.
4. Remove the four screws, then remove the SY-354

board

SY-354 board (Side B)
CN503
CN003
CN504
CN002
CN501
CN702
CN502
CN701
CN506
Flexible flat cables
Flexible flat cables
Harness
Harness
Flexible flat
cables
5. To install, reverse the removal procedure.
n
Replace the removed tape (A) and tape (L40) with the
new tape.
CN001
CN505
Tape (L40)
Tape (A)
Harness
PSW
2.6 x 6
SY-354
board
BRC-Z700