Installing The 2.5-Inch Drive Cage Cover - Dell EMC PowerEdge C4140 Installation And Service Manual

Figure 34. Removing the 2.5-inch drive cage cover
Next steps
Replace the 2.5-inch drives.

Installing the 2.5-inch drive cage cover

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the drive cage.
4. If applicable, install the 2.5-inch drives into the drive
5. Connect the power and signal cables to the drive in the drive cage.
NOTE: Ensure that the connector labeled HDD0 is plugged into upper drive before reinstalling bay.
Steps
1. Lower the drive cage cover onto the drive cage.
2. Slide the drive cage cover toward the back of the cage to engage it with the slots on the drive cage.
3. Use the screws to secure the drive cage cover to the drive cage.
36 PowerEdge C4140 installing and removing system components
Safety instructions
Before working inside your
cage.
section.
system.