Table of Contents
Advertisement
Figure 60. Removing the network daughter card
Next steps
Replace the network daughter
card.
Installing the network daughter card
Prerequisites
Follow the safety guidelines listed in
Safety instructions
on page 23.
Steps
1. Orient the NDC so that the Ethernet connectors fit through the slot in the chassis.
2. Align the captive screws at the back-end of the card with the screw holes on the system board.
3. Press the touch points on the card until the card connector is firmly seated on the system board connector.
4. Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the system board.
PowerEdge C4140 installing and removing system components
61
Advertisement
Table of Contents
