Installing The Intrusion Switch - Dell EMC PowerEdge C4140 Installation And Service Manual

Figure 38. Removing the intrusion switch
Next steps
Replace the intrusion switch.

Installing the intrusion switch

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Align and slide the intrusion switch into the slot in the system.
2. Connect the intrusion switch cable connector to the connector on the system board.
Figure 39. Installing the intrusion switch
40 PowerEdge C4140 installing and removing system components
Safety instructions
Before working inside your system
on page 23.
on page 24.