Table of Contents
Advertisement
5. Holding the system board holder, slide the system board toward the front of the chassis.
Sliding the system board toward the front of the chassis disengages the connectors on the system board from the
connector slots on the back of the chassis.
6. Lift the system board out of the chassis.
Figure 100. Removing the system board
Next steps
Install the system
board.
Installing the system board
Prerequisites
Follow the safety guidelines listed in
Steps
1. Unpack the new system board assembly.
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
CAUTION:
Take care not to damage the system identification button while placing the system board into the
chassis.
2. Holding the system board holder, align the connectors on the system board with the slots on the chassis, and slide the
system board towards the back of the system.
3. Using Phillips #2 screwdriver, tighten the screws to secure the system board to the chassis.
94
PowerEdge C4140 installing and removing system components
Safety instructions
on page 23.
Advertisement
Table of Contents
