Removing The Sxm2-Gpu Heat Sink - Dell EMC PowerEdge C4140 Installation And Service Manual

Removing the SXM2-GPU Heat Sink

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the NVLink air
Steps
1. Using a Phillips #1 screwdriver, loosen the screws on the heat sink in the order that is mentioned below:
a. Loosen the first screw three turns.
b. Loosen the screw diagonally opposite to the screw you loosened.
Figure 84. Removing the SXM2-GPU heat sink screws
2. Repeat the procedure for the remaining two screws.
3. Return to the first screw to loosen it completely.
4. Following the same diagonal pattern, loosen the remaining screws completely.
5. Lift the heat sink from the NVLink board.
Safety instructions
Before working inside your
shroud.
PowerEdge C4140 installing and removing system components
section.
system.
81