Table of Contents
Advertisement
Figure 62. Removing the system battery
3. To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4. Press the battery into the connector until it snaps into place.
Figure 63. Installing the system battery
Next steps
1.
Install the expansion card riser
2. Follow the procedure listed in
3. While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
4. Enter the correct time and date in the System Setup Time and Date fields.
5. Exit the System Setup.
Optional internal USB memory key
NOTE:
To locate the internal USB port on the system board, see the System board jumpers and connectors section.
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Locate the USB port or USB memory key on the system board.
To locate the USB port, see the
2. If installed, remove the USB memory key from the USB port.
3. Insert the replacement USB memory key into the USB port.
1.
After working inside your system
Safety instructions
Before working inside your system
Jumpers and connectors
PowerEdge C4140 installing and removing system components
on page 24.
on page 23.
on page 24.
section.
63
Advertisement
Table of Contents
