Table of Contents
Advertisement
4. PNEUMATIC CONNECTORS
The pneumatics connectors are located on the rear side.
4.1. A
UTOMATIC CONNECTOR
4.2. P
NEUMATICS TEST OUTPUTS
These outputs enable parts to be connected (test, reference). The pressurization output
is used for the addition of ATEQ accessories (Y valve).
Inputs / Outputs on the rear side of the F670:
4.3. QUICK
CONNECTORS
One quick connector may be mounted on the front panel of the
instrument.
This connector is to check the calibration. It's used to check the test
circuit and enables, by use of a calibrated leak, calculation of the
equivalent pressure drop.
connections must be air tight.
MR-36300C-U
A
B (
AND
To drive pneumatics caps.
Reference Output R
Pressurization Output
Test Output T
(
)
OPTION
As this connector is part of the measurement circuit, all its
)
OPTION
Quick start manual ATEQ F670 Page 11/25
Quick start - F670
Advertisement
Table of Contents
