Getting Started With The Video Demonstration - Xilinx Kintex-7 FPGA KC705 Getting Started Manual

Chapter 1: Getting Started with the Kintex-7 FPGA KC705 Embedded Kit
What's Available Online
•
•
•

Getting Started with the Video Demonstration

This Kintex-7 FPGA embedded kit comes with a video demonstration available on the
embedded kit home page. This demonstration can be run before installing any additional
tools to get an overview of the features of the KC705 evaluation board using a MicroBlaze
processor subsystem in the Kintex-7 (XC7K325T-FF900-2) FPGA.
Processor System Used for the Video Demonstration
The provided video demonstration uses a pre-built Kintex-7 FPGA design
with these features:
•
•
•
•
•
•
•
•
•
8
Send Feedback
License for Vivado Design Suite:
• Licensing Solution Center
• Xilinx Licensing FAQ
Embedded kit home page with documentation and reference designs:
• Kintex-7 FPGA Embedded Kit
Technical Support
MicroBlaze processor
External DDR3 SDRAM interface
External flash memory interface
On-chip memory (block RAM)
Integrated Tri-Mode Ethernet MAC
UART (connected from the KC705 board via the USB-UART connector)
Interrupt controller (Intc) and timer
GPIO (LCD, LEDs, buttons, switches, and rotary)
Software-configurable XADC block
www.xilinx.com
(Figure 1-1)
KC705 Getting Started Guide
UG913 (v4.1.1) March 7, 2014