Open The Secondary Bus Window; Configure A Virtual Relay Output - Emerson Rosemount 2410 Reference Manual

Advanced configuration
December 2019
C.4

Open the secondary bus window

The Rosemount 2410 Secondary Bus is used for communication with emulated devices. It
supports many different modems and protocols such as the TRL2 Modbus, Enraf, Varec,
and L&J.
Procedure
1. In the TankMaster WinSetup workspace, right-click the Rosemount 2410 Tank Hub
2. Choose the Properties option.
3. Select the Configuration tab.
4. Click the Secondary Bus button.
C.5

Configure a virtual relay output

The Rosemount 2410 has two relays which can be configured with one or two set points.
Virtual relay output, (Disabled, Relay1, Relay2), source, set-point etc. can also be
specified.
The Rosemount 2410 Tank Hub supports virtual relay functionality that lets you specify up
to ten source parameters to control the two hardware relays. The output of a virtual relay
can be directed towards any of the two relays, allowing a high configuration flexibility. You
may, for example, use one of the relays (Relay1 or Relay2) as a high level alarm for several
tanks by using Level as source parameter for each tank. Many other configurations are
possible using the two relays for various virtual relay configurations.
162
d) Click Apply to store the current configuration, or click OK to store the
configuration and close the Primary Bus Configuration window.
icon.
The 2410 Tank Hub window appears.
The Secondary Bus Configuration window allows you to change protocol, baudrate,
address, and other communication settings.
Reference Manual
00809-0100-2410
Reference Manual