RGBlink X7 User Manual page 72

Step 5: Cover the fan with the black panel and lock them by screws.Place the fan module back to
the device and tighten the screw.
1. Clean fan on the rear panel
Step 1: Loosen the screws between side
panel and wings by hex screwdriver.
Step 3: Remove the IDC line connected to the
back panel after dismantling the front panel.
Press the fastener on both rims by thumb and
index finger to take off the line.
Step 5: Reverse the steps above
Insert the IDC line back to the back panel.
Put back the front panel and lock the screws between front panel and base, and then tighten
X7
Step 2: Loosen the screws between front
panel and base by cross screwdriver.
Step 4:Clean the the dust on the fan.
User Manual
71