Chapter 2 Install Your Product; Plug In Signals; Plug In Main Power; Turn On Your Product - RGBlink X7 User Manual

Chapter 2 Install Your Product

2.1 Plug in Signals

Connect signals to the product (ensure all the device are all power off first).Tighten connector
screws/locks where provided.
Please use cable that can support HDMI 2.0 or DP 1.2 to ensure 4K@60Hz input and
output when 4K signal is used.
Connect RS232 port of device and computer with DB9-RJ11 serial cable or connect LAN port of
device and computer with network cable or connect both device and computer to the same
router, make sure their IP address is not completely same.

2.2 Plug in Main Power

Connect IEC cable to device and plug into wall socket. Turn on power at wall socket.
If the devices is restarted, make sure the indicator light upon the PSU module is totally out
before plugging in the power.

2.3 Turn on Your Product

Turn on the power switch on the rear panel.
OLED display will show as below,completing initialization before loading the latest settings and
input/output configuration.
The system begins to work,and the OLED module shows the input slot and output slot
X7 User Manual
10