RGBlink X7 User Manual page 21

After Sync, XPOSE will show the actual input and output modules installed in the list below.
5. Configure the filed application to add signal type. On the above IN /OUT list, the second
column is signal type and the third column is actual port types installed. Choose the signal type
according to port. For example, output module 4 is a DVI module, all ports are DVI. Add DVI
signal to this module.
If 4 signal type on the one module is the same as the actual modules installed, choose Model
Univeral, in drop down list there are singal type according to the all modules this device
supported.
Input module Output module
If each signal is different choose Model as Typical, user can add signal port by port.
X7 User Manual
20