GE LOGIQ P6 Series Service Manual page 348

GE H
EALTHCARE
5394152, Revision 5
D
IRECTION
8-4-3 Installing Application Software
NOTE: First time SW installation with peripherals on can cause the BlueScreen.
NOTE: When connecting peripherals to the system, make sure to turn off the system first in order to avoid the
BlueScreen.
Base Image software should also be installed prior to the application.
WARNING WARNING
1.) Place the "Application Software" CD into the DVD drive.
2.) Press the Start button on the tool bar at the bottom of the LCD screen and select "Run".
Enter "G:\LoadSoftware" into the dialog box as shown below.
3.) You will see a Command (CMD) window open as shown in
4.) Press the "Y" key twice and copying backup files starts. This takes a few minutes.
Page 8-122
Figure 8-181 Run Load Software
Figure 8-182 Command Window
Section 8-4 - Software Installation
LOGIQ™ P6/P6 P S
RO ERVICE
Figure 8-182.
M
ANUAL