GE LOGIQ P6 Series Service Manual page 115

GE H
EALTHCARE
5394152, Revision 5
D
IRECTION
4-7-2 Sub Keyboard Assy Function Validation Procedure
1.) Boot up the system and run the scfpapitest program.
Follow up the procedure
NOTICE
run the scfpapitest program.
2.) Press and Rotary sub keyboard, and Paddle (up/down, right/left) button.
3.) Check the log dialog box in scfpapitest program
Table 4-9
4-7-3 Trackball Assy validation
1.) Boot up the system.
2.) Press the measurement button.
3.) Move the Trackball.
When you move the trackball in measurement mode, the cursor should be moved.
4-7-4 A/N Key assy validation
1.) Boot up the system.
2.) Press 'Comment' button.
3.) Press A/N keyboard.
Each key should be displayed on the monitor display.
4-7-5 Freeze key validation
1.) Follow up the procedure
to run the scfpapitest program.
2.) Press Freeze button and check up the Log dialog box if the freeze key was release.
After pressing Freeze button, Freeze button message should be displayed into Log dialogbox on
NOTICE
scfpapitest program.
4-7-1 "Main Keyboard Assy Function Validation Procedure" on page 4-26
Button and Rotary Table
Button or Rotary Name
1 (Button/Rotary)
2 (Button/Rotary)
3 (Button/Rotary)
4 (Button/Rotary)
5 (Button/Rotary)
Up
Down
Left
Right
4-7-1 "Main Keyboard Assy Function Validation Procedure" on page 4-26
The Name displayed in Log
PushEncoder 1 of Touchpanel Button/Rotary
PushEncoder 2 of Touchpanel Button/Rotary
PushEncoder 3 of Touchpanel Button/Rotary
PushEncoder 4 of Touchpanel Button/Rotary
PushEncoder 5 of Touchpanel Button/Rotary
Paddle Up Button
Paddle Down Button
Paddle Left Button
Paddle Right Button
Chapter 4 -
LOGIQ™ P6/P6 P S
RO ERVICE
M
ANUAL
to
Page 4-29