Procedure: Performing A Remote Loopback Test; Remote Loopback Test - Avaya 6424D+M User Manual

Chapter 3: Using the Front Panel
Page 3-16

Remote Loopback Test

The remote loopback test can be initiated by the front panel
interface or the Remote Loopback (RL) lead on the V.35 interface.
This test is used to send data to a remote endpoint and check the
returned data for errors.
You must be on a data call to run a remote loopback test.
The following procedure contains step-by-step instructions for
initiating a remote loopback test from the front panel interface.
Refer to Remote Loopback Test section in Chapter 6, ''Test
Descriptions'' for details of this test.

Procedure: Performing a Remote Loopback Test

Press NEXT/NO or BACK until the HSL displays REMOTE
1
LOOPBACK?
Press ENTER/YES to begin the remote loopback test. The
2
HSL displays
REQUESTING TEST
TEST STARTED
END REMOTE LOOP?
(The HSL displays END REMOTE LOOP? while the test is
active.)
The POWER/TEST lamp winks during the test and stops
winking when the test is completed.
Notes: If the HSL is optioned for V.54 loopback and the
remote data endpoint fails to respond to the
request, the test aborts and the HSL displays
REQUESTING TEST
NO RESPONSE
REMOTE LOOPBACK?
If you attempt to start a remote loopback test when
the HSL is not in the data mode, the HSL displays
DENIED
NOT IN DATA MODE
REMOTE LOOPBACK?
DEFINITY Communications System
DEFINITY High Speed Link
User´s Guide