Connecting The New Hsl To The Switch - Avaya 6424D+M User Manual

DEFINITY Communications System
DEFINITY High Speed Link
User´s Guide
Connecting the New HSL to
the Switch
Procedure: Connecting the
New HSL to the Switch
The HSL can be connected to the switch in several ways,
depending on the configuration of the HSL and its associated
equipment. Installation components supplied will differ
according to how the installation kit was specified at the time it
was ordered. The following procedures cover each of several
installation configurations.
New Installation: Ordered as Attribute 1 or 6
The following items, specific to this installation, are required:
WP90780L2 adapter harness (referred to as L2 in this
procedure), supplied with the installation kit (attribute 1)
or
individual D8W telephone cords, one supplied with each HSL
(attribute 6)
Use the following procedure for connecting new units to the
switch with the items supplied in installation kit having attribute
1 or 6.
If you are using the L2 adapter harness (attribute 1):
1
Attach the 50-pin connector to the B25-type cable from
a
the switch as shown in Figure 2-5.
Note: Refer to Table 2-1 at the end of this chapter for
standard wiring information to the switch.
Chapter 2: Installation
Page 2-7