Avaya 6424D+M User Manual page 18

Chapter 2: Installation
Page 2-4
Procedure: Installing a
Single HSL
Use the following procedure to install a single unit:
Plug the D8W telephone line cord into the connector labeled
1
LINE.
Plug the free end of the telephone line cord into the
2
telephone wall jack assigned to your HSL.
Plug the V.35 cable from the synchronous terminal
3
equipment into the connector labeled V.35 on the HSL.
If the RS-366/RS-232 interface is used, connect the RS-
4
366/RS-232 interface cable and the associated dialing
equipment.
Plug the power supply cord into the connector labeled
5
POWER.
Plug the other end of the power supply cord into an AC
6
power outlet.
The unit powers on as soon as the AC cord of the power
supply is connected to a live AC power outlet. As the HSL
performs its startup self-test, the system displays the
following messages on the front panel.
SELF TESTING
SELF-TEST PASSED
REL 1.0, VER 1.0
IDLE
Note: The HSL displays multiple line messages one line at
a time.
If everything is normal, the HSL dispays the IDLE message.
Should the HSL fail self-test, the system displays different
messages than what is shown above. If this happens, refer to
the Self-Test section in Chapter 3, ''Using the Front Panel.''
For administration information on switched and permanent
applications, refer to Appendix D, ''Applications and Switch
Administration.''
DEFINITY Communications System
DEFINITY High Speed Link
User´s Guide