Dialing A Data Call; Manual (Front Panel); Chapter 5: Call Control Operation - Avaya 6424D+M User Manual

DEFINITY Communications System
DEFINITY High Speed Link
User´s Guide

Chapter 5: Call Control Operation

DIALING A DATA CALL

MANUAL (Front Panel)

This chapter discusses the guidelines and procedures for
operating the DEFINITY High Speed Link from the front panel,
RS-366 interface, RS-232 interface, DTR dialing, and HOTLINE.
When you dial a call, you must provide the HSL with the number
of the called endpoint. You can select one of the following
methods for dialing a data call depending on your equipment:
RS-366 interface (number supplied by data equipment)
RS-232 interface (number supplied by data equipment)
DTR dialing (number stored by user in the HSL memory)
HOTLINE (number supplied by the switch)
MANUAL (dialing from the front panel only).
Notes: When using the RS-366/RS-232 interface, the DTR input
lead on the V.35 interface must be ON or the DTR LEAD
option must be set to IGNORE before you can dial a call.
The DTR lead option must be set to NORMAL for DTR
and HOTLINE dialing.
Calls may be dialed manually using the front panel when
either the RS-366 or RS-232 dial method is selected, but
not for DTR or HOTLINE.
Procedure: Dialing a call through the front panel
Press ENTER/YES when the HSL displays Call
1
Control? The HSL displays DIAL? if the HSL is idle.
Press ENTER/YES while DIAL? is displayed. The HSL
2
displays DIAL: nnn...?, where nnn... is the number
stored in memory location M0.
Note: If the stored number is more than 9 digits, DIAL is
omitted and only the number is displayed.
Press NEXT/NO to step through the four memory locations
3
to select the desired stored number.
Press ENTER/YES when the desired number is displayed,
4
and the HSL dials the number.
Chapter 5: Call Control Operation
Page 5-1