Restrictions On Using Sbc In Sleep Mode - NXP Semiconductors UJA116 A Series User Manual

NXP Semiconductors

6.4.8 Restrictions on using SBC in Sleep mode

UM11379
User manual
After executing a Sleep mode command successfully (UJA1168AF-EVB and
UJA1168AXF-EVB only), the SBC turns off the 5 V output on V1 supplying the
microcontroller. As a result, the connection between the GUI and the SBC will be lost
after a short delay. This needs to be taken into account when testing the Sleep mode
command using the Register map tab or when executing scripts that include a Sleep
mode command.
To resume GUI operation after the SBC has entered Sleep mode, the SBC must be
woken up via an enabled wake source (CAN and/or WAKE pin). The GUI then needs to
re-connect to the board.
All information provided in this document is subject to legal disclaimers.
Rev. 1 — 23 April 2021
UM11379
UJA116xA evaluation boards
© NXP B.V. 2021. All rights reserved.
45 / 56