Table of Contents
Advertisement
NXP Semiconductors
6
FlexGUI: interactive register control via USB
6.1 FlexGUI software package overview
6.2 Preparations for using the S32K144EVB as a USB interface
6.2.1 FlexGUI firmware installation on S32K144EVB
UM11379
User manual
This section only applies to evaluation boards that feature an SBC with SPI interface:
• UJA1164A-EVB
• UJA1168AF-EVB
• UJA1168AXF-EVB
When the UJA116xA-EVB is plugged onto a suitable microcontroller evaluation
board, the microcontroller board can be used as a USB/SPI interface between the
UJA116xA-EVB and a PC. After installing the FlexGUI application on a Windows PC
(see
Section
6.3), the contents of the SBC registers can be viewed and/or changed
interactively.
FlexGUI for UJA116xA-EVB currently supports the following evaluation board:
• S32K144EVB, Rev. B
See
www.nxp.com
for more information about this board.
Figure 20. Using FlexGUI with S32K144EVB as USB/SPI interface
The FlexGUI SW package for the UJA116xA-EVB can be downloaded from
www.nxp.com. It includes:
• the flexGUI PC installer (see also
• FlexGUI firmware for all supported microcontroller boards (see also
The FlexGUI firmware must be loaded into the S32K144EVB before connecting the
UJA116xA-EVB. Note that the jumper settings for firmware programming are different to
those for FlexGUI usage.
Firmware programming in the S32K144EVB is straightforward:
1. Confirm that the jumpers are in the correct position for firmware programming
(Figure
21)
2. Connect the board to the PC with a USB cable
All information provided in this document is subject to legal disclaimers.
(Figure
20)
Section
6.3)
Rev. 1 — 23 April 2021
UM11379
UJA116xA evaluation boards
Section
(Figure
22)
© NXP B.V. 2021. All rights reserved.
6.2.1)
29 / 56
Advertisement
Table of Contents
