Table of Contents
Advertisement
NXP Semiconductors
3
Connecting the UJA116xA to a CAN network
3.1 Connecting boards without an SPI (UJA1161A/62A/63A/66A-EVB)
UM11379
User manual
The following conditions must be met before powering up the system with a 12 V supply.
Common to all boards:
• Connect all boards in the ECU to a common GND
• Connect pin CTS (J3-03, J4-09) to an MCU IO input pin
• Connect pin STBN/SLPN (J3-06, J4-09) to an MCU IO output pin
• Connect TXD/RXD (J3-01/J3-02, J4-18/J4-20) pins to the MCU CAN controller TXD/
RXD pins
• Connect CANH and CANL (J1-01/J1-02) to the CAN bus twisted-pair cables
Board specific:
• Connect VIO (J3-09, J5-03) on the UJA1161A-EVB, UJA1162A-EVB and UJA1166A-
EVB to the MCU supply unit; VIO shares the MCU IO supply
• Connect RST (J3-09, J5-05) on the UJA1163A-EVB to the MCU CAN controller RSTN
pin
• Connect V1 (J3-08, J5-03) on the UJA1163A-EVB to the MCU supply unit
• Connect V1 (J3-08, J5-03) on the UJA1166A-EVB to the application circuit to be
supplied from V1
• Connect INH (J3-10) on the UJA1162A-EVB and UJA1166A-EVB to the control/enable
pin on the ECU supply unit (optional)
Once the above steps have been completed, the ECU/EVB can be powered up using
an external battery supply. The UJA116xA starts up in Standby mode and then switches
between Standby/Sleep modes and Normal mode depending on the level on pin STBN/
SLPN.
An example of how to connect the UJA1163A-EVB between an MCU and the CAN bus is
shown in
Figure
11.
All information provided in this document is subject to legal disclaimers.
Rev. 1 — 23 April 2021
UM11379
UJA116xA evaluation boards
© NXP B.V. 2021. All rights reserved.
15 / 56
Advertisement
Table of Contents
