Removal Of The Needle Bearing - Rotax 915 i A Series Maintenance Manual

REMOVAL OF THE NEEDLE BEARING

Preparation – CONFIGURATION 2 AND 3
• Remove the governor flange according to the in-
struction in section Governor flange —
Step Procedure
1 Loosen M5x12 hex. screw with thrust
washer from the engine block.
Figure 6.20: TYPICAL
1 M5x12
Step Procedure
2 Mount press-in jig part no. 276000 to the
needle bearing.
3 Install the threaded pin of special tool part
no. 276004 through the plunger and the
oil inlet flange. Fix it with the knurled nut
on the other side.
Effectivity: 915 i A Series
Edition 0/Rev. 1
BRP-Rotax
MAINTENANCE MANUAL HEAVY
removal.
2
Thrust washer
Figure 6.21: TYPICAL
Needle bearing
1
Press-in jig part no.
3
276000
Knurled nut of tool
5
276004
Procedure
Step
4 Install extractor part no. 877615 with 6
screws onto the propeller gearbox.
5 Screw extractor spindle and threaded pin
of special tool part no. 276004 together.
2 Oil inlet flange
Threaded pin of tool
4
276004
72–10–00
Page 15
June 01 2019