Assembly Of The Propeller Gearbox Assy - Rotax 915 i A Series Maintenance Manual

Figure 6.76
1 Overload clutch
Procedure
Step
11 Insert centering ring part no. 276950.
12 Press damper clutch assy. with insertion
jig part no. 276952.
ATTENTION
The upper disk spring must not slip into the
groove of the retaining ring. Otherwise disk
spring will be damaged during compression of
the clutch.
Step Procedure
13 Insert circlip and release damper clutch
assy.
NOTE
Check the alignment of clutch hub
once again. It must be free to move.
Effectivity: 915 i A Series
Edition 0/Rev. 1
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Damper clutch assy.
2
1 Clutch hub
Circlip
3
Figure 6.77: TYPICAL
ASSEMBLY OF THE PROPELLER
GEARBOX ASSY.
Damper clutch— installation
Step Procedure
1 Install the whole gearbox to support plate
part no. 276958 and fix both in a bench
vice.
2
Lubricate the propeller shaft with LOC-
TITE ANTI SEIZE on the gear-tooth.
3 Install damper clutch into the housing.
NOTE
There is only one position to install the damper
clutch. It is indexed through the splines of the
propeller shaft.
2 Insertion jig
72–10–00
Page 45
June 01 2019