Ocpp Backend - ABB EVLUNIC PRO M Configuration Manual

4.2.4. RFID authorization with OCPP backend connection
If the charging station or a charging network is controlled by an OCPP backend, please note the
following:
• Teach in RFID cards:
All RFID cards must be "centrally taught in" at the OCPP backend.
• "Authorization" in the web interface to "ON":
Each authorization request is relayed to the OCPP backend.
• "Authorization" in the web interface to "OFF":
A charging process can only be started without holding up an RFID card if the predefined token
set in the configuration is recognized and accepted by the OCPP backend.
Information
For information on the functionality and the required settings of the OCPP backend, refer to the
specific manual of the system used.
4.2.5. Start charging process with RFID authorization
To start a charging process with RFID authorization, proceed as follows:
1. Plug the vehicle into the charging station.
2. Hold the RFID card, which was previously taught in, in front of the RFID reader.
3. The rising tone sequence and the green flashing LED bar indicate that the RFID card has been
accepted.
The charging process can now be started by the vehicle.
4. If necessary, the charging process can be stopped prematurely by holding the same RFID card in front
of the RFID reader again.
Information
Enable input X1
For special device variants, the enabling of a charging session can also be controlled via the enable
input X1 (for connecting external components such as a timer, photovoltaic system or home control). If
this function has been activated in the DIP switch settings, enabling a charging session will
additionally require a correct signal on the enable input X1. Further information can be found in the
"Installation Manual".

4.3. OCPP backend

The charging station offers the option of being connected to a central management system via the
Open Charge Point Protocol (OCPP). OCPP, as an open application protocol, makes it possible to connect
any central management system to the charging station regardless of the manufacturer or supplier.
STATUS
Released
© Copyright 2019 ABB. All rights reserved.
DOCUMENT ID.
TBA
CHARG ING STATIO N
REV. LANG. PAGE
A EN 30/37