ABB EVLUNIC PRO M Configuration Manual page 22

External TCP Meter
Here you can set whether the charging station can read out the measured values from external meters
for dynamically adjusting the charging current. All the necessary configurations for the external meter
can be found in this part. This menu is only available if the charging station is operated as a single
charging station (not available on charging network).
Display Text
Settings for the text can be made here, which is shown on the display and describes various operations
of the charging station. The language of the text can be changed, the display duration can be set and
the displayed text itself can be changed.
The display text is limited to 20 characters, no special characters or umlauts can be used.
3.3.2. User menu
The user menu contains important information and settings for the user. It is divided into the following
areas:
• Help
• Licenses
• User Settings
• Logout
User Settings
This section allows you to make changes to the following user settings:
Username and Password
The web interface user name and associated password can be changed here.
Remote Service Interface
The remote access to the charging station can be activated here. This allows a service technician to
access the charging station via an encrypted connection. This setting can also be made at the OCPP
backend.
Log Level
For error diagnosis, it may be necessary to record the operations of the charging station in detail. The
DEBUG mode can be activated in this area for this purpose. To prevent the recorded data volume from
becoming too large, the duration for the detailed recording must also be specified.
Recovery Key
If you have forgotten the web interface password, you can reset it with the displayed recovery key. The
recovery key can also be found on the configuration label.
STATUS
Released
© Copyright 2019 ABB. All rights reserved.
DOCUMENT ID.
TBA
CHARG ING STATIO N
REV. LANG. PAGE
A EN 22/37