ABB EVLUNIC PRO M Configuration Manual page 16

The DIP switches are located under the connection panel cover. The following figure shows only the
affected DIP switches, others are not shown. The following setting must be made on the DIP switch
DSW2:
Activation of communication - DSW2.5
Function
Activation of communication
STATUS
Released
© Copyright 2019 ABB. All rights reserved.
Information
Changes to the DIP switch settings only become effective after a restart of the
charging station!
To restart, press the "Service button" until the first beep (approx. 1 second) or
switch off the charging station for a short time via the line circuit breaker
Figure
DOCUMENT ID.
TBA
CHARG ING STATIO N
REV. LANG. PAGE
A EN 16/37