ABB EVLUNIC PRO M Configuration Manual page 11

2.1.3. WLAN Access Point (Hotspot) (optional)
EVLunic Pro M can be connected to a mobile device via the integrated WLAN access point. With the
mobile device, the web interface can be easily accessed and the configuration of the charging station
can be performed.
1 EVLunic Pro M
The access data and the IP address of the WLAN access point are listed on the configuration label. The
configuration label is in a pouch which is enclosed with the mounting material.
The following steps are necessary to perform the configuration via a mobile device:
1. Connect a mobile device to the WLAN access point.
2. Access the IP address of the WLAN access point in a web browser on the mobile device.
3. Perform configuration via the web interface, see 3.3 Configuration via web interface.
2.1.4. GSM (optional)
Certain device variants have a GSM module. EVLunic Pro M with GSM can connect to an OCPP backend
over the cellular network. The mobile communications provider may charge additional fees (depending
on the tariff) for running data transmissions.
1 EVLunic Pro M
For the connection to an external OCPP backend via GSM, a SIM card must be installed during
commissioning. In addition, GSM must be activated as connection to the OCPP backend and the
access data of the mobile service provider must be set in the configuration (web interface).
STATUS
Released
© Copyright 2019 ABB. All rights reserved.
2 OCPP backend
DOCUMENT ID.
TBA
CHARG ING STATIO N
REV. LANG. PAGE
A EN 11/37