ABB EVLUNIC PRO M Configuration Manual page 29

Teaching in a master RFID card
To access the "Service button", the housing cover and the connection panel cover must be removed.
1. Press and hold the "Service button" in the connection panel until the second signal tone is sounded
(approx. 10s).
The charging station will then automatically perform a restart, deleting all previously taught-in RFID
cards, if necessary.
2. The charging station will be available again after 30 seconds.
3. After the waiting time, the first three segments of the led bar are illuminated. A master RFID card can
be taught in for 30 seconds by holding it in front of the RFID reader.
A successful teach-in process is confirmed by a rising tone sequence.
Teaching in a slave RFID card
1. Hold the master RFID card in front of the RFID reader and wait for the rising tone sequence.
2. Then hold the slave RFID card to be programmed in front of the RFID reader within 10 seconds and
wait for the signal tone.
3. Confirm the teach-in process by holding up the master RFID card again within 5 seconds.
A successful teach-in process is confirmed by a rising tone sequence.
Managing RFID cards in the web interface
RFID cards can be managed via the configuration in the web interface. The following functions are
available:
• Teaching-in, editing or deleting an RFID card
• Exporting or importing a list of stored RFID cards as *.csv file
Information
It is recommended to use a text editor for editing the *.csv file. Otherwise the date can be interpreted
incorrectly upon import.
The following entries can be made during teaching-in and editing of an RFID card:
Entry
RFID Card – Serial No. (UID)
Expiry Date
Master RFID Card
Status
Charging Station – Serial No.
STATUS
Released
© Copyright 2019 ABB. All rights reserved.
Description
Serial number (UID) of the RFID card. This can be read out with a
suitable mobile phone app, for example.
Date up to which the RFID card is to be valid.
Set the RFID card as master RFID card. Only one card can be
defined as master RFID card.
Authorization of the RFID card. Here it is also possible to block an
RFID card and thus prevent charging with the relevant RFID card.
Serial number of the charging station where the RFID card may be
authorized. All or only certain charging stations in the charging
network can be enabled for the RFID card.
DOCUMENT ID.
CHARG ING STATIO N
REV. LANG.
TBA A EN
PAGE
29/37