ABB EVLUNIC PRO M Configuration Manual page 20

WLAN Access Point Info
The state of the WLAN access point (hotspot) is displayed.
Logging
Different event logs of the master charging station are displayed.
DSW settings
The DIP switch settings of each charging station in the charging network can be displayed here.
Restart System
The master charging station can be restarted using this button.
Configuration
The configuration of the charging station is carried out in this area.
Information
The DIP switch settings are independent of the web interface configuration and cannot be overwritten
by software.
The area offers the following options:
• Operating Mode
• Device
• Phase Assignment
• Charging Parameters
• Network Connection
• Certificates
• WLAN / WiFi Access Point
• Proxy
• OCPP
• External TCP Meter
• Display Text
Information
The settings made are only applied after the "Apply" button has been pressed.
Operating Mode
Here you can determine whether the charging station is operated as a single charging station or as a
master charging station in a charging network.
The number of slaves must be entered for a charging network. In addition, all attached slave charging
stations must be entered with their respective serial numbers. Otherwise, the slave charging station will
not be recognized by the master charging station in the network. The serial number is printed on the
rating plate of the slave charging station.
STATUS
Released
© Copyright 2019 ABB. All rights reserved.
DOCUMENT ID.
TBA
CHARG ING STATIO N
REV. LANG. PAGE
A EN 20/37