Notes On This Document - ABB EVLUNIC PRO M Configuration Manual

—
Fig. 1-1: Screws on front part
The front part 1 may not be opened. Opening the front part (4 Torx screws) will break the warranty seal
and void the warranty. For a warranty claim, there is a duty of proof of the customer that the defect –
which led to the defect of the device – already existed at the time of delivery. If the warranty seal is
broken, this proof can no longer be provided, whereby the warranty claim expires.
A device with broken warranty seals or removed lead seals may no longer be put into operation. The
necessary steps for replacement or repair of the charging station by the specialist dealer or service
partner must be initiated.

1.5. Notes on this document

The manual is part of the product. It is to be retained over the entire life cycle of the product and should
be forwarded to any subsequent owners or users of the product.
The instructions contained in this manual must be followed precisely. Failure to do so could result in the
creation of potential sources of danger or the disabling of safety devices. Apart from the safety
instructions given in this manual, the safety precautions and accident prevention measures appropriate
to the situation in question must also be observed.
1.5.1. Contents of the document
• Configuration of the advanced features of EVLunic Pro M
1.5.2. Not contained in this document
• Commissioning and deinstallation of the charging station
• Operating behavior of the charging station
• Operation of the charging station
STATUS
Released
© Copyright 2019 ABB. All rights reserved.
DOCUMENT ID.
TBA
CHARG ING STATIO N
REV. LANG. PAGE
A EN 6/37