Table of Contents
Advertisement
Probe Recognition Check
NOTE:
Peripheral Device Check
LOGIQ C9 Series – Basic Service Manual
5482298-100 English Rev. 5
After the system software loading completion, please check to
ensure that the system can recognize the probes.
Plug in the probe. In scanning mode, the probe information is
displayed on the right top location of the screen. About the
probe specification for intended use on LOGIQ C9 Series.
Plug in at least one of each type of the probes and check if each
of the probes is recognized and the probe information is
displayed correctly.
Figure 8-14. Probe identification
Check to ensure that all the peripheral devices work properly.
For instruction of peripheral device check, See 'Peripheral
checks' on
page 4-25 for more information.
Loading the software
8-23
Advertisement
Table of Contents
