Set Up The Smb Workgroup Name - Canon Oce TDS Series Administration Manual

Set up the SMB workgroup name

Procedure
1. Switch the Océ Settings Editor in SA Mode on page
2. Select 'Connectivity' - 'SMB' - 'Workgroup name'
3. Type in the new workgroup name in the input field.
NOTE
This field is mandatory once the SMB printing protocol is enabled. You must fill it in,
otherwise the controller will continuously reboot.
4. Click 'Apply'.
You are proposed to reboot the controller.
Either click 'OK' and go on with the other parameters setup, or, once all setups are done, reboot
the controller (see
Océ TDS/TCS/TC Connectivity information for Windows environments
Reboot the controller on page
Set up the SMB workgroup name
128.
130).
Chapter 2 - Configure the print system controller 41