Enable Print Protocols; Enable Lpd/Lpr Protocol; Enable Lpd Protocol For Océ Tds/Tcs Systems (Except Océ Tds7X0, Océ Tcs300) - Canon Oce TDS Series Administration Manual

Enable print protocols

Enable LPD/LPR protocol

Before you begin
• You MUST be logged on as a system administrator.
• The LPD/LPR protocol is enabled by default on the Océ Wide-format printing systems. Make
sure it is enabled on your printing system.
Enable LPD protocol for Océ TDS/TCS systems (except Océ TDS7x0,
Océ TCS300)
Procedure
1. Switch the Océ Settings Editor in SA Mode.
2. Select 'Connectivity' - 'LPD' - 'Enable LPD'.
3. Select 'Enabled' on the right panel ('Enable LPD').
4. Click 'Apply'.
You are then proposed to reboot the controller.
Either, click 'OK' and go on with the other parameters setup, or, once all the setups are done,
reboot the controller.
Océ TDS/TCS/TC Connectivity information for Windows environments
Chapter 2 - Configure the print system controller
Enable print protocols
33