Powering Up The Development Kit - Lantronix Open-Q 212A User Manual

3.5.2 Powering Up the Development Kit

1. At a static-safe workstation, remove the development kit board carefully from the anti static bag.
2. Connect the serial debug USB (17) to your favorite terminal program if you wish to see boot
messages (FTDI UART — USB bridge driver required on PC).
3. Connect the Power Adapter to the 12V DC Jack (11) and then press and hold the POWER ON button
(26) for a few seconds until the blue LED starts blinking to indicate the board is booting up.
4. Once the board is booted up you can log into the console with the following username and password:
Username: root
•
Password: oelinux123
•
Open-Q™ 212A Development Kit User Guide
Open-Q 212A Development Kit
13