Fig. 39: Positioning Of The Safety Belt When Used With The Dahl Docking Station - Paravan WHEELCHAIR Series Operating Instructions Manual

> The upper body restraining belt must pass over the shoulder and chest, as shown in Fig. 47.
> The belt strap of the restraining belt must not be twisted during use.
> When putting on the passenger restraint system, care must be taken to ensure that the belt buckle is
positioned so that the release button is not touched by wheelchair components in the event of a collision.

Fig. 39: Positioning of the safety belt when used with the Dahl Docking Station

80
WARNING
Positioning of the safety belt only when used with the Dahl
docking system
> If the Dahl docking system is used, the floor anchoring
points for the safety belts must be located 10 - 60 mm
outside the wheels of the wheelchair. The lap belt must
sit flat over the front of the pelvis so that the angle of the
lap belt lies within 30° – 75°. As shown, a steeper (higher)
angle within the zone of 45° – 75° is preferred, i.e. closer to,
but never more than, 75°.
Loading and transporting the power wheelchair